Hi all,
I run into trouble when I try to configure the Madplay under
my cross-platform development.
After I untar the package I do follwing step to setup the
Madplay entironment.
export CC=arm-lynx-linux-bluecat-gcc
export RANLIB=arm-lynx-linux-bluecat-ranlib
export LD=arm-lynx-linux-bluecat-ld
export NM=arm-lynx-linux-bluecat-nm
./configure --build=i386-linux --host=arm-linux --target
=arm-linux --enable-fbm=arm -enable-sso --prefix=/bluecat/cdt
--exec-prefix=/bluecat/cdt
then the config procedure and make procedure pass smoothly but
when make install I trap into the trouble
I reported yesterday:
make[1]: Entering directory `/bluecat/mad/po'
if test -r
"../././././mkinstalldirs"; then \
../././././mkinstalldirs
/usr/local/share; \
else \
/bin/sh ../././mkinstalldirs
/usr/local/share; \
fi
../././././../././././mkinstalldirs: Can't open
../././././../././././mkinstalldirs
I modified the makefile maually today by delete the following
line in makefile
SUBDIRS = intl po
$(libz) libid3tag libmad $(winamp)
the make install pass and all thing seem OK.
But when I try to run the madplay on my target board(Ep7312)
the follwing message display
bash# ./madplay -o raw:- ./funky.mp3 >/dev/null
MPEG
Audio Decoder 0.14.2 (beta) - Copyright (C) 2000-2001 Robert Leslie
2373
frames decoded (0:01:01.9), -2.2 dB peak amplitude, 0 clipped
samples
bash#
But there have not any noise during this procedure when the
BlueCat demo run OK.
There some question confuse me,
1) What's the function of directory under mad name po,msvc++
and intl ?
2) Is there anything wrong with my ./configure
procedure?
Pls give me advice.
Thank for you help and Merry Xmas.
With regards, healy
yang
E-mail:healy_yang@china-SSI.com
____________________________________________________________
Sichuan Starlight Internet-appliances Ltd. 升威信息电器公司
Tel:
(86-28) 5185891
Fax: (86-28) 5136351